Feature request

[highlands]

The new graph is real nice! Can it be refined in two ways?

(1) have the graph only show the highs and lows of the voltage? i.e. no need to waste graph space on 0 to about 45 volts if the voltage did not go that low during the period in the graph. This way we see more fine information of the voltage. Another way to say it would be have the bottom of the graph start at 2 to 5 volts below the lowest point of the voltage within the time period and about 2 to 5 volts above the upper highest voltage.

(1) maybe change the 24 hour graph to 36 hours so we can see some over lap of information it will show the same day to day curves of the voltage. This would be nice to compare the information from day to day if needed.


Thanks for adding this software feature to the WS-8-150-DC and the WS-12-250-DC is there any chance, it time it will in time be added to the WS-12-DC and the WS-6-Mini?

John