I've enabled the port on the port page, and confirmed that the port is enabled in the configuration via the console "show status" command.
However, I can not get an Ethernet link. The GUI still shows it's disabled.
can't enable port
-
dcox - Member
- Posts: 27
- Joined: Sat Nov 07, 2015 8:33 pm
- Location: Champaign, IL
- Has thanked: 5 times
- Been thanked: 2 times
can't enable port
I'm attempting to "enable" port 2 on this switch, I can't get the web gui display to show it is enabled.
I've enabled the port on the port page, and confirmed that the port is enabled in the configuration via the console "show status" command.
However, I can not get an Ethernet link. The GUI still shows it's disabled.
I've enabled the port on the port page, and confirmed that the port is enabled in the configuration via the console "show status" command.
However, I can not get an Ethernet link. The GUI still shows it's disabled.
-
sirhc - Employee
- Posts: 7416
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: can't enable port
1) What firmware version are you running?
2) Did you modify the config file manually?
If the port does not belong to a VLAN then it is disabled, check your VLANs, the port needs to belong to at least one VLAN
2) Did you modify the config file manually?
If the port does not belong to a VLAN then it is disabled, check your VLANs, the port needs to belong to at least one VLAN
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
-
dcox - Member
- Posts: 27
- Joined: Sat Nov 07, 2015 8:33 pm
- Location: Champaign, IL
- Has thanked: 5 times
- Been thanked: 2 times
Re: can't enable port
1.4.3rc7
no modifications to the config file manually.
It was the VLAN issue, its good now. Thanks!
no modifications to the config file manually.
It was the VLAN issue, its good now. Thanks!
3 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 64 guests