Switch (DC 26 port) failed while in service
- David Lee
- Member
- Posts: 24
- Joined: Fri Jun 30, 2017 3:21 pm
- Has thanked: 3 times
- Been thanked: 1 time
Switch (DC 26 port) failed while in service
Installed new out of box WS-26-500-DC 3-4 weeks ago. Made sure that device was well grounded and powered up ports only after the 1 x AF24 and 5 x sectors (Mikrotik 24VDC) were plugged in. Firmware was updated. This evening the device lost power to all ports that had previously been turned on. When attempting to access to troubleshoot and reboot, we were not able to enter the device. Swopped out with backup and brought the faulty one back to work bench. Followed instructions for resetting to default. Did not see a light show in any form. No lights at all. Held reset button for 20-30 seconds, let sit for 5-10 minutes and still could not access device. What am I doing wrong?
-
sirhc - Employee
- Posts: 7416
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: Switch (DC 26 port) failed while in service
You may not be doing anything wrong, this could simply be a failure or possibly damage, sadly can not tell until we see it?
If you're applying power to it and there is not green LED indicator in the front within 10 seconds then it is not powering up at all.
You will need to RMA it .
Please explain the site, DC power source, grounding system, and radio equipment powered from switch.
Explaining your grounding:
Are the AC service ground rods BONDED to the tower ground rods with a direct heavy cable like #2?
If you're applying power to it and there is not green LED indicator in the front within 10 seconds then it is not powering up at all.
You will need to RMA it .
Please explain the site, DC power source, grounding system, and radio equipment powered from switch.
Explaining your grounding:
Are the AC service ground rods BONDED to the tower ground rods with a direct heavy cable like #2?
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
- David Lee
- Member
- Posts: 24
- Joined: Fri Jun 30, 2017 3:21 pm
- Has thanked: 3 times
- Been thanked: 1 time
Re: Switch (DC 26 port) failed while in service
Site: 130 ft Rohn tower built on a semi rocky setting
DC power source: Tripp Lite APS1250 Inverter with 2 12 dc deep cycle tied together in series
grounding: earth ground bonded with commercial power ground in cabinet
radio equipment: 1 x AF24 (48VDC), 5 X Mikrotik RB921 (24VDC)
Not sure what AWG is used. Net time I'm at the site I'll verify.
DC power source: Tripp Lite APS1250 Inverter with 2 12 dc deep cycle tied together in series
grounding: earth ground bonded with commercial power ground in cabinet
radio equipment: 1 x AF24 (48VDC), 5 X Mikrotik RB921 (24VDC)
Not sure what AWG is used. Net time I'm at the site I'll verify.
3 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 60 guests