command line configuration

[justech]

I am trying to program some switches using the command line "config" mode but it seems to be missing some ways of setting a few things.

I have not been able to set LAG Aggregation Modes or turn on the discovery tab.

Is there something I am missing or is it just not in there?

[justech]

Also, interface port 1-12 does not alter ports 1-12, only the first port in the range. This is 1.4.9 btw.

[Eric Stern]

I am trying to program some switches using the command line "config" mode but it seems to be missing some ways of setting a few things.

I have not been able to set LAG Aggregation Modes or turn on the discovery tab.

Is there something I am missing or is it just not in there?

You are correct, there are a few things missing from the CLI.

[Eric Stern]

Also, interface port 1-12 does not alter ports 1-12, only the first port in the range. This is 1.4.9 btw.

You cannot specify a port range. When you hit ? and it shows "<1-14>", it is showing you the range of valid port numbers, not suggesting that you are allowed to specify a range of ports.

[justech]

I am trying to program some switches using the command line "config" mode but it seems to be missing some ways of setting a few things.

I have not been able to set LAG Aggregation Modes or turn on the discovery tab.

Is there something I am missing or is it just not in there?

You are correct, there are a few things missing from the CLI.

When can the LAG settings get added? The discovery tab thing is very minor but the LAG stuff is important.