We've tested this on various switch and it appears that any WS12-dc when running 12v and the input current exceeds 13.9amp the reading goes to NaN.undefined. It also appears that this will frequently stay that way even if the switch drops below 13.9. However if the load has been reduced below and you power cycle the switch the issue reset's it's self.
Tested on 1.5.0 and 1.5.5
NaN.undefined when input current exceeds 13.9amp
-
LRL - Experienced Member
- Posts: 238
- Joined: Sun Nov 23, 2014 4:00 am
- Location: Rock Springs, WY
- Has thanked: 18 times
- Been thanked: 49 times
NaN.undefined when input current exceeds 13.9amp
-LRL
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
1 post
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 67 guests