Page 1 of 1
Native VLAN other than VLAN1
Posted: Thu Oct 08, 2015 4:35 pm
by Techn0
When configuring a dot1Q trunk, how do you change the native vlan? This is on a WS-12-250-DC
Re: Native VLAN other than VLAN1
Posted: Thu Oct 08, 2015 5:12 pm
by sirhc
Techn0 wrote:When configuring a dot1Q trunk, how do you change the native vlan? This is on a WS-12-250-DC
You simply change the Default VLAN ID (THe first VLAN in the list)
The first VLAN in the list must always be there, that is the VLAN that the UI and CLI exist on but you can change the ID and the Description.
It would be silly to allow this VLAN to be deleted as there MUST always be one VLAN.
Re: Native VLAN other than VLAN1
Posted: Thu Oct 08, 2015 5:15 pm
by Techn0
Ok, that makes sense. I am used to a command line interface and I'm struggling with the port-based VLAN gui (haven't used anything quite like it since my old CMM days). LOL, you made the interface too easy for me. Back to lab testing....about to deploy our first Netonix here!
Re: Native VLAN other than VLAN1
Posted: Thu Oct 08, 2015 5:17 pm
by sirhc
Techn0 wrote:Ok, that makes sense. I am used to a command line interface and I'm struggling with the port-based VLAN gui (haven't used anything quite like it since my old CMM days). LOL, you made the interface too easy for me. Back to lab testing....about to deploy our first Netonix here!
We have a NEW firmware do out very soon MUCH NICER!