Netonix Forums

This thread is for posts regarding v1.3.9rcX BETA / RC

Issues fixed since v1.3.8

v1.3.9rc14 - Release 1/15/2015
- Fixed SNMP using 100% CPU
- Fixed config revert not working
- Added enable/disable VLAN to CLI

v1.3.9rc13 - Released 1/7/2016
- fix for clearing log
- added "clear log" CLI command

v1.3.9rc12 - Released 1/4/2016
- Fixed per-port graphs that were broken if switch was up less than 1 hour
- Fixed condition where DC2DC power supply failed to wake up switch from hibernation mode
- Fixed where unresolvable hostname could hang syslog server
- Fixed DC power supply voltage range
- Added LLDP Discovery
- Now retains log if log daemon is restarted
- CLI no longer saves config unless something was changed

v1.3.9rc8 - Released 12/15/2015
- Fixed UBNT Discovery name
- Ping Watchdog now disabled if port is disabled
- Changing Safe Mode Timer and ability to disable Safe Mode
- Ability to reset counters per port instead of all
- Log file formatting
- UI Enhancement for MAC table
- Add clear stats command to CLI

v1.3.9rc7 - Released 12/10/2015
- Fixed UBNT Discovery - FINALLY
- Fixed Linux log

v1.3.9rc6 - Released 12/02/2015
- Fixed Loop protection log entry refers to wrong port number
- Fixed Broadcast storm when using LACP and RSTP [Discovered by Thomas]
- Fixed Unable to change RSTP path cost for LAGs

v1.3.9rc4 - Released 11/30/2015
- Changed from mini-snmpd to net-snmp, a more common and well tested snmp daemon.

v1.3.9rc2 - Released 11/24/2015
- Fixed MAC table eating up CPU time when you have hundreds and hundreds of MAC entries. [Discovered by Francisco]

Upgraded one WS-12-250-DC to 1.3.9rc4 to see if it would fix my SNMP issues. Upgrade went smoothly, now only time will tell. Usually takes about a week before issues pop up.

Dawizman wrote:Upgraded one WS-12-250-DC to 1.3.9rc4 to see if it would fix my SNMP issues. Upgrade went smoothly, now only time will tell. Usually takes about a week before issues pop up.

Thanks you for posting and testing!

RC2 has 90% smoothed out the CPU issues on our network! Thanks for getting this out so fast.

Updated a WS-12-250A RevB switch from 1.3.6 ->1.3.9rc2, no drama, and voltages in Power section of status screen now report properly with generic Addon SX gbic installed.

Dawizman wrote:Upgraded one WS-12-250-DC to 1.3.9rc4...

Where is this firmware available from? Is rc4 the latest and if so why are others more recently reporting on rc2?

Hey Les,

It is right under the download of v1.3.8

Who'da thunk it would be under stable? Not me.

I upgraded a MINI to rc4. The linux log bug I reported earlier is still there.

lligetfa wrote:Who'da thunk it would be under stable? Not me.

I upgraded a MINI to rc4. The linux log bug I reported earlier is still there.

Same thing with the WS-24

v1.3.9rc6 released see release notes above