Page 1 of 1
WS-12-250-DC Board Voltage errors
Posted: Sat Feb 27, 2016 5:13 pm
by bgoode
New-just-out-of-the-box WS-12-250-DC switch w/ v1.3.8 (purchased from a distributor) shows board voltage reading errors. No POE enabled on any port.
Tried upgrading to v.1.3.9 with no change....factory reset with no change...downgrade to v1.3.8 and still no change.
RMA time?
Re: WS-12-250-DC Board Voltage errors
Posted: Sat Feb 27, 2016 5:29 pm
by lligetfa
Are there any SFPs plugged into the switch? Is this being bench tested or at a tower site? If tower site is it near a high power FM transmitter?
Re: WS-12-250-DC Board Voltage errors
Posted: Sat Feb 27, 2016 6:07 pm
by bgoode
No SFP's and it on the bench in the office....
Re: WS-12-250-DC Board Voltage errors
Posted: Sat Feb 27, 2016 6:30 pm
by Dave
weird...can you post a screen shot of entire status page?
Re: WS-12-250-DC Board Voltage errors
Posted: Sat Feb 27, 2016 6:50 pm
by sirhc
We hand test each unit several times before we ship, really hard to believe it would do that out of the box?
Re: WS-12-250-DC Board Voltage errors
Posted: Sat Feb 27, 2016 6:59 pm
by bgoode
Also noticed the Power Supply Efficiency bar is showing red and >85%. Other WS-12-250-DC switches in production with the same voltage input of 23.8v show efficiency at >92% in the green.
Re: WS-12-250-DC Board Voltage errors
Posted: Sat Feb 27, 2016 7:00 pm
by sirhc
RMA it back for us to examine:
viewtopic.php?f=6&t=1259