Page 1 of 1
Board temp error
Posted: Sat Apr 30, 2016 4:43 pm
by suge
I am getting a board temp error after upgrading to 1.4 rc12
Re: Board temp error
Posted: Mon May 09, 2016 1:58 pm
by suge
This is fixed now in RC16
Re: Board temp error
Posted: Fri Mar 02, 2018 11:21 am
by swang2002
I'm running firmware 1.4.8 on WS-24-400a board revision D, and I am getting the board temp "error" as well. Also, my fans aren't on all the time, and just kick on every once in a while. I wouldn't say this is a problem, but my CPU and PHY temps are around 100c. I haven't logged into this switch in quite some time, but I just wanted to see if this is a problem, or if it is standard behavior to only see the fans kick on for a few moments every minute or two with the temperatures that high.
Re: Board temp error
Posted: Fri Mar 02, 2018 11:53 am
by sirhc
Well first thing I would try is rebooting it, and while your at it upgrade to v1.4.9.
If no love try a power cycle not just a warm reboot.
If still a failure then you have a hardware issue and you need to RMA it.
Re: Board temp error
Posted: Thu Mar 22, 2018 3:04 pm
by swang2002
So far so good after a soft reboot/firmware upgrade. Unrelated to the topic, but any idea on when MSTP will be out of beta?
Re: Board temp error
Posted: Thu Mar 22, 2018 3:18 pm
by sirhc
swang2002 wrote:So far so good after a soft reboot/firmware upgrade. Unrelated to the topic, but any idea on when MSTP will be out of beta?
No Idea on MSTP, right now working on issue with WS-26-500-DC
After that I need to get with Mike99 and see if he has a list of things for Eric and then push Eric to fix them