Netonix Forums

Hello Support,
I am having issues changing the IP address of a switch via the CLI. I am using putty as the terminal, when I change the IP:
Configure terminal
ip address 192.168.x.x
The commands are input and I am able to connect via another putty session for a time. The config reverts to the original settings because I was not able to confirm the configuration.
Is there a way to do this via CLI? The GUI is unresponsive on all firmware versions I have tried. (v1.4.0rc22, v1.3.9). The Minis do not have a serial port. It would be great to do as I have 30+ devices to configure.
Cheers,
RDon

Try using a different browser like Chrome as the UI is very responsive, has to be your browser or computer. Our UI is VERY responsive.

If you go under the Device/Configuration Tab in the UI you can disable the Revert Timer by setting it to "0" then it will never revert config even if you screw up.

Yes Chrome works 100x faster thank you.
Also the revert timer will be useful.

Cheers,