Netonix Forums

I have a switch that says Error for wattage/temperature. This was running 1.3.7, upgrading it to 1.4.3rc4 has no effect.

There's no difference with the APs unplugged or not.

Screenshots attached

This normally happens when the switch takes damage and the current sensors are blown.

Since all the sensors use the same I2C bus if the switch took a bad enough hit it can take out the I2C bus and all the sensors report error like that.

Could be a failure or could be damaged wither way we can repair it.

If it is a failure the repair is free if it is damaged we charge a fee to replaced the board.

Here is where you get RMA instructions: viewtopic.php?f=6&t=1259


Here are some good posts on grounding:
viewtopic.php?f=30&t=1816
viewtopic.php?f=30&t=188
viewtopic.php?f=30&t=1429
viewtopic.php?f=17&t=1786&start=30#p13447