Netonix Forums

Hello

I find the voltage indicating on the WS-8-150 is not very accurate ...
I have a shift of 0.3 which is still important on our batteries ...
What adjustment can be made to find the right voltage compared to a multimeter?

Thank you

PERSONNE ???????

This is being looked at for a future version of firmware. As of now, there is no provision for calibrating the input voltage on-board. I've been told that if there is a difference between a multimeter reading and the value the UI reports that the difference will stay constant, (in other words, if UI states 50.2 and actual is 50.5, then if the actual is 48.5, the UI will report 48.2) if that helps in establishing a workaround for the moment.

Hope this helps!

ok merci !