Page 1 of 1
Problem to power up
Posted: Mon Nov 20, 2017 2:34 am
by muhammedmunas
Netonix switch ( WS-8-150-DC ) has a problem to power up equipment using POE, when enabling the voltage weather 48volt or 24 it works only for few minutes then switches of equipment but when trying to use the with no POE its working properly.
How to solve this issues ? is it possible to solve remotely ?
Re: Problem to power up
Posted: Mon Nov 20, 2017 8:28 am
by sirhc
Please provide some information.
Make sure your running v1.4.8
Describe how your powering the WS-8-150-DC
Describe your site.
Re: Problem to power up
Posted: Mon Nov 20, 2017 10:27 am
by muhammedmunas
The site is a tower where we are co-siting for our radio network.
The site has AC power and solar which charges a battery bank. This battery bank has an output of 48volts which we tapped through to a circuit breaker then to our Netonix switch.
Re: Problem to power up
Posted: Mon Nov 20, 2017 12:49 pm
by sirhc
muhammedmunas wrote:The site is a tower where we are co-siting for our radio network.
The site has AC power and solar which charges a battery bank. This battery bank has an output of 48volts which we tapped through to a circuit breaker then to our Netonix switch.
Questions:1) Firmware version, if not v1.4.8 please upgrade
2) Is this a positive or negative DC site? (if this is negative 48V that is your problem)
You should bench test this unit as described in this post:
viewtopic.php?f=6&t=2780#p19221