Netonix Forums

I have one of the larger chassis WS-12-250B. We experienced an overheating issue, we replaced it with a spare identical model. When back on the shop bench, we replaced both fans inside.

I factory reset the 250B after replacing the fans. All ports appear to be working fine and both fans are spinning.

In the device log it says this:

Code: Select all

 
Dec 31 19:00:50 dropbear[1321]: Running in background
Dec 31 19:00:52 switch[1359]: Detected warm boot
Dec 31 19:01:02 switch[1340]: Warning: expected 2 fans but found 1
Dec 31 19:07:18 switch[1340]: Fan 2 is now working

Both fans are blowing.

status page shows this:


Is this something that means I should send it in for replacement or something to not worry about?

firmware is 1.5.0 btw

My guess is the board is damaged or failed?

Its an older unit so not sure I would repair it if I was you but your call.

We do not have replacement boards for that unit anymore as it has been EOL for almost 3 years.