Page 1 of 1
WS-8-150DC Calibrate Voltage not working
Posted: Tue Jun 19, 2018 5:03 pm
by jason.brand@wanna.net.nz
Hi,
i have a WS-8-150DC on fw 1.5.0 (latest), calibration does not work .if i do calibrate via gui its current voltage is 27.3, so i enter 27.9 but stays at 27.3, also tried via cli but stays same 27.3 reading, also tried various other voltage but always showing 27.3,below is output of CLI
stopped process in pidfile '/var/run/switch-g' (pid 2533)
Enter current input voltage: 28.3
Input voltage reading: 27.30
Multiplier is 1.037
Writing multiplier to configuration...
Unlocking /dev/mtd1 ...
Writing from /tmp/cfg to /dev/mtd1 ...
stopped process in pidfile '/var/run/switch-g' (pid 2977)
after did this expected gui to sat 28.3 but instead says 27.3. any ideas?
Re: WS-8-150DC Calibrate Voltage not working
Posted: Tue Jun 19, 2018 5:30 pm
by sirhc
Stephen or Eric is looking into this for you.
Re: WS-8-150DC Calibrate Voltage not working
Posted: Tue Jun 19, 2018 6:15 pm
by jason.brand@wanna.net.nz
Hi, just tried another WS-8-150DC brand new out of the box, same problem this was on firmware 1.4.9 both switches are board revision F.
Also pulled 250DC model and tried that, worked as it should so problem seems to be confined to WS-8-150DC
Re: WS-8-150DC Calibrate Voltage not working
Posted: Tue Jun 19, 2018 10:13 pm
by Stephen
Thanks for bringing this to our attention. I've been able to confirm it is a bug specific to the ws-8-150-dc model and will have it patched on the next release.
Re: WS-8-150DC Calibrate Voltage not working
Posted: Tue Jun 19, 2018 10:15 pm
by jason.brand@wanna.net.nz
Any idea timeframe for release as we rely on voltage reading for our off grid sites where this switch going into.or can u do quick rc release for me?
Re: WS-8-150DC Calibrate Voltage not working
Posted: Tue Jun 19, 2018 11:26 pm
by sirhc
jason.brand@wanna.net.nz wrote:Any idea timeframe for release as we rely on voltage reading for our off grid sites where this switch going into.or can u do quick rc release for me?
v1.5.1rc1 will be released tomorrow.....is that OK?
Re: WS-8-150DC Calibrate Voltage not working
Posted: Tue Jun 19, 2018 11:28 pm
by jason.brand@wanna.net.nz
Thats is very OK and very impressed with your service and product, could not ask for any better.
Look forward to the RC release tomorrow, if you could let me know when available for download that would be great and keep up the fantastic work.
Re: WS-8-150DC Calibrate Voltage not working
Posted: Wed Jun 20, 2018 4:44 pm
by sirhc
jason.brand@wanna.net.nz wrote:Thats is very OK and very impressed with your service and product, could not ask for any better.
Look forward to the RC release tomorrow, if you could let me know when available for download that would be great and keep up the fantastic work.
v1.5.1rc1 is now available for download with this fix for you.