Netonix Forums

I am getting this error on all ports on a WS-12-250-DC "Error loading cable diagnostics". I have a Ubiquiti PBE-M2-400 and it's pulling 25-30 watts rather than the normal 3-5 watts and I don't know if it's the radio or the cable. The radio is passing traffic normally. I've re-booted the radio several times and re-booted the switch. The other radios all seem to be drawing the 3-5 watts.


Has anyone seen this before or have any ideas of what could be the cause?

Thanks

John

Possibly a damaged switch.

Pull from service and Bench Test it: viewtopic.php?f=6&t=2780#p19221

Will do. It's also giving me the message 'Error saving configuration!'. Then it takes a long time to apply, but it does when I refresh the screen.

I'll let you know the results early next week.

John

Thanks sirhc

Finally got the switch on the bench and upgraded the firmware. It seems to be working just fine now.

JohnWall wrote:Thanks sirhc

Finally got the switch on the bench and upgraded the firmware. It seems to be working just fine now.

I would factory default it in case there is any corruption in the config file.