Netonix Forums

I have just upgraded our oldest Netonix (12 port DC) to 1.5.5 - which was a mission on its own, because it did not survive the upgrade from 1.44, so I had to climb the tower and do a console based factory install from scratch in the lab....

But it is now up and running and showing:
Firmware Version1.5.5
Board Rev F
Power Supply Firmware Version 70
Power Supply Board Rev B

But the input voltage graph on the Status page is not autoscaling. This is a feature I would love to have. Anything I can do to make it happen - please don't say I have to take the network down and scale the tower again ...

That shouldn't be necessary, Most likely you need to clear out the cache for the page in your browser and refresh the page.

Thanks Stephen,
That did the trick - not terribly obvious to me though ...