Firmware v1.2.0rc6 bug reports and comments

[sirhc]

Please post comments and report bugs for v1.2.0rc6 in this thread.

FIXES
- Fixed scrolling on status page
- Fixed DHCP when changing the management VLAN ID
- Fixed SNMP stats for new models
- Fixed stats for new models in CLI
- Fixed problem with SFP ports not showing correct STP state on 12 port models
- Fixed problem configuring STP Priority
- Fixed MAC table sometimes showing filtered entries
- Ensure flashing 48VH PoE LED remains on during reboot

ENHANCEMENTS
- Added fallback to static IP configuration if DHCP fails
- Added DHCP Snooping
- Added Ubiquiti Discovery
- Added Cisco Discovery
- Added TFTP auto backup for config
- Added buttons to reorder VLANs
- Added support for WS-6-MINI, WS-8-250-DC, WS-12-250-AC and WS-12-250-DC
- Added Power tab for DC models
- Added current ratings to PoE settings in UI
- Added board rev to flash configuration
- Added CLI command to show vlans
- Added CLI command to change ID of VLANs

[lligetfa]

No issues except the length of the date line still jumps around.

[sirhc]

No issues except the length of the date line still jumps around.

I did pass that along to Eric, I too do not like things that jump around. When things move I think OH NO!

[FLHSI]

So far this has fixed our Last SFP (26, Or 14 on the 12port model) CRC errors when interfaced with a Mikrotik Cloud Core. Thanks guys!

[sirhc]

No issues except the length of the date line still jumps around.

You did both switches right Les?

[lligetfa]

Yes, installed on both switches.

[lligetfa]

The wattage shown going out port 1 that feeds the MINI is reporting less than the MINI reports.

Selection_010.jpg (97.39 KiB) Viewed 7726 times

he numbers on the MINI appear to be too high.

Selection_011.jpg (155.55 KiB) Viewed 7726 times

[sirhc]

Well, the watts are updated every second so is it possible they are fluctuating? - PROBABLY NOT THAT MUCH

Can you post some current graphs, 30 second & 5 min ?

I would post the 24 port graphs feeding the WS-6-MINI

I am wondering if in the new firmware version Eric is not adding the 2 pair current sensors?

When using a VH port Eric has to add the 2 current sensors together, I am thinking there is a BUG in the new v1.2.0rc6 where he is only reporting half or 1 pair.

I am betting he is only reporting 1 pair/sensor value.

WHich would make sense, 60W's seems about right, I would bet that the load varies 5-7+/- watts from reading to reading possibly?

We should have put a sensor on port 1 to read the input current, maybe next spin.

So if you assume 24 port port 1 is reporting HALF if actual load then 59+ watts and the 6 MINI at the moment you took the screen cao is 57.7 watts that lines up pretty good.

[lligetfa]

Selection_012.jpg (29.71 KiB) Viewed 7723 times

Selection_013.jpg (30 KiB) Viewed 7723 times

[lligetfa]

Selection_014.jpg (28.66 KiB) Viewed 7723 times

Selection_015.jpg (31.18 KiB) Viewed 7723 times