Netonix Forums

v1.2.0rc7 wrote:
FIXES
- Fixed several cosmetic requests

ENHANCEMENTS
- Firmware up-grader for DC power supply processor

KNOWN ISSUES
- Cable Diagnostic is broken
- Disabled ports shows lightening bolt instead of X

v1.2.0rc6 wrote:
FIXES
- Fixed scrolling on status page
- Fixed DHCP when changing the management VLAN ID
- Fixed SNMP stats for new models
- Fixed stats for new models in CLI
- Fixed problem with SFP ports not showing correct STP state on 12 port models
- Fixed problem configuring STP Priority
- Fixed MAC table sometimes showing filtered entries
- Ensure flashing 48VH PoE LED remains on during reboot

ENHANCEMENTS
- Added fallback to static IP configuration if DHCP fails
- Added DHCP Snooping
- Added Ubiquiti Discovery
- Added Cisco Discovery
- Added TFTP auto backup for config
- Added buttons to reorder VLANs
- Added support for WS-6-MINI, WS-8-250-DC, WS-12-250-AC and WS-12-250-DC
- Added Power tab for DC models
- Added current ratings to PoE settings in UI
- Added board rev to flash configuration
- Added CLI command to show vlans
- Added CLI command to change ID of VLANs

sirhc wrote:I upgraded all my switches in service today with v1.2.0rc7 but this is not saying you should...

lligetfa wrote:

sirhc wrote:I upgraded all my switches in service today with v1.2.0rc7 but this is not saying you should...

I upgraded my WS24. Should I try this on the MINI?

lligetfa wrote:OK, flashed the MINI. Watts still reporting the same. (yes, I know... not in the release notes).