Page 1 of 1
WS-26-DC Switch Not Reporting Out Current Draw (Amps)
Posted: Fri Feb 05, 2021 1:39 pm
by tbuttrick
We have many 8 and 12 port DC Netonix switches and they report out current draw in Amps. However, the WS-26-DC does not. Have tried firmware 1.5.5 and 1.5.6 without success in this value reporting.
Has anyone seen this and found a fix?
Re: WS-26-DC Switch Not Reporting Out Current Draw (Amps)
Posted: Fri Feb 05, 2021 3:18 pm
by mike99
DC or IDC ?
From the IDC page: Does not allow monitoring of DC input voltage
https://netonix.com/wisp-switch/ws-26-400-idc.html
Re: WS-26-DC Switch Not Reporting Out Current Draw (Amps)
Posted: Fri Feb 05, 2021 3:45 pm
by tbuttrick
Dc, not IDC
Re: WS-26-DC Switch Not Reporting Out Current Draw (Amps)
Posted: Sun Feb 07, 2021 11:11 am
by mike99
This model ?
https://netonix.com/ws-26-dc.htmlNot sure but it seem it's a model without smart power supply and I think this stat is only available on model with smart power supply like following model:
https://netonix.com/wisp-switch/ws-26-500-dc.html
Re: WS-26-DC Switch Not Reporting Out Current Draw (Amps)
Posted: Sun Feb 07, 2021 4:26 pm
by lligetfa
AFAIK, any switch that does not include the wattage in the model number does not have a power supply and as such is intended to be hooked to a regulated power source. As Mike said, it is the smart power supply that reports the out current draw.
Re: WS-26-DC Switch Not Reporting Out Current Draw (Amps)
Posted: Mon Feb 08, 2021 1:10 pm
by tbuttrick
Thanks to you both.