Netonix Forums

Just wondering when we can expect to see a stable software release for this switch line.

Now that they are finally getting built and shipped again, I have many places I would like to deploy these switches, but the unstable software is holding that back.

I have a stack of 7-8 of these units sitting in a pile in the corner. Unable to use them. Not sure it is a "Software" problem anymore?

All running latest 2.0.8 firmware. Aren't able to even finish configuring them before they lock up and are useless !

This on the list to address hopefully soon....

We are looking into this, however, so far on my test unit, configurations apply in seconds (including VLAN's, LAG's, etc).
Thus far, I have not been able to reproduce the WS3 locking up or any real delay when changes are applied.

Would anyone be able to provide a configuration and/or configuration changes that have been shown to lock up the WS3 or at least seem to take a very long time to apply?

It may also be helpful to know more about the networking layout the WS3 is being used in to reproduce and hopefully fix these issue's.

The issues of config changes causing issues on WS3 units was there in previous firmware versions but that was fixed to my knowledge in latest WS3 firmware version.

But as Stephen asked please provide a way to recreate your issue with the latest firmware and he will look into it.