It's strange I've been running 1.2.2 for quite a while and haven't had any switches complaining about fans, but over the last week I've gotten several alerts from one switch.
In the log I see "switch[743]: Fan 2 is failing"
Fan2 seems to be in line with fan1 speed wise most of the time, but it doesn't seem to rev as high. Can someone tell me what the parameters are that trigger the fan failing alerts?
Fan 2 is failing
-
LRL - Experienced Member
- Posts: 238
- Joined: Sun Nov 23, 2014 4:00 am
- Location: Rock Springs, WY
- Has thanked: 18 times
- Been thanked: 49 times
Fan 2 is failing
-LRL
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
-
Eric Stern - Employee
- Posts: 532
- Joined: Wed Apr 09, 2014 9:41 pm
- Location: Toronto, Ontario
- Has thanked: 0 time
- Been thanked: 130 times
Re: Fan 2 is failing
If the fan is turned on and the fan speed stays below 1500 rpm for 3 seconds it is considered to be failing. The code will never run the fan that slow, so if it is going that slow something must be wrong with it.
-
sirhc - Employee
- Posts: 7415
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: Fan 2 is failing
But please upgrade to newest firmware and see if the fan failure persists.
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
-
LRL - Experienced Member
- Posts: 238
- Joined: Sun Nov 23, 2014 4:00 am
- Location: Rock Springs, WY
- Has thanked: 18 times
- Been thanked: 49 times
Re: Fan 2 is failing
I haven't seen a warning since the upgrade. I think I'll let it run and see if anything else comes up.
-LRL
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
"My reading of history convinces me that most bad government results from too much government." - Thomas Jefferson
- keefe007
- Experienced Member
- Posts: 169
- Joined: Tue Aug 05, 2014 3:56 pm
- Has thanked: 0 time
- Been thanked: 21 times
Re: Fan 2 is failing
I have this on a switch running 1.3.2. The failing fan RPM shows 1600 or so.
5 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 53 guests