Hi-
I've been searching through the forums and have thus far been unable to find an answer to the following question:
Do any of your switches support Modbus RTU or TCP slave mode? We have a customer that is interested in using your products for a deployment and we are hoping to collect telemetry data from your switch from a Modbus master device we will have on site.
Appreciate any feedback from the community!
Austin
Modbus RTU/TCP Slave
- ajcappon
- Member
- Posts: 1
- Joined: Mon Apr 15, 2019 1:35 pm
- Has thanked: 0 time
- Been thanked: 0 time
-
Stephen - Employee
- Posts: 1034
- Joined: Sun Dec 24, 2017 8:56 pm
- Has thanked: 85 times
- Been thanked: 182 times
Re: Modbus RTU/TCP Slave
Yes, if you go to the configuration page on the very bottom there is a panel called "Serial Proxy" this is one of the options, it will change the rs232 port to a modbus interface that will allow the switch to act as a tcp proxy.
As shown here:
As shown here:
- Modbus Serial Proxy.PNG (5.82 KiB) Viewed 4356 times
-
sakita - Experienced Member
- Posts: 206
- Joined: Mon Aug 17, 2015 2:44 pm
- Location: Arizona, USA
- Has thanked: 94 times
- Been thanked: 80 times
Re: Modbus RTU/TCP Slave
That configuration allows using the serial port on the switch to interface with a MODBUS device.
It sounded to me like the OP was looking to use MODBUS to gather data *from* the switch itself.
It sounded to me like the OP was looking to use MODBUS to gather data *from* the switch itself.
Today is an average day: Worse than yesterday, but better than tomorrow.
3 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 95 guests