Powering a Cambium Force300 from a DC switch

[ewolff06]

I know this is an old thread but I came across it in a Google search looking for other information, so here's the answer.


The original run of Force 300 radios use a reverse polarity pinout like the old Canopy equipment (and the non-GPS ePMP 1000 radios). To get an old stock force 300 to power on a Netonix switch, you *need* to use a Tycon rollover cable, then it will work no problem. New stock F300s does not require the rollover cable. Below is a post that helps identify which hardware revision a radio is based on serial number and a link to the rollover cable.


https://community.cambiumnetworks.com/t ... port/62267

https://www.tycononline.com/POE-Crossov ... p_162.html