Netonix Forums

I'm not entirely sure when things broke, but somewhere in 1.3 my SNMP stopped working. I've tried version 1 and version 2c. I get lots of messages about unhandled UDP packets on the switch (only a warning perhaps).

However, using Cacti I can no longer get the switch to return any results. I upgraded to 1.3.7 and now I can get Cacti to get the interface names and such, but I'm still getting 0 for throughput.

This worked in 1.1.x and 1.2.x versions.

Are you using the new MIB file?

viewtopic.php?f=17&t=251

I haven't loaded the new MIB, but I should still be able to pull interface information without that, no? Throughput is, as the link even states, using standard MIB information.

Any ideas? Nothing I do is making this work.

Are you making sure to configure the switch to the proper SNMP version on the Device/Configuration Tab?

Yes,
I have tried both 1 and 2c and neither works. Both will allow Cacti to pull up information about the switch, including interface names and capacity, but the reported throughput counters are always 0.

mhoppes wrote:Yes,
I have tried both 1 and 2c and neither works. Both will allow Cacti to pull up information about the switch, including interface names and capacity, but the reported throughput counters are always 0.

I have never used Cacti. I have hear others on here talking about it though?

Eric is hard at work fixing some issues for firmware v1.3.8 but after that he is supposed to take several days and set up several SNMP servers and verify we have no issues.

I made it work with PRTG traffic grapher but I get no traffic (similar results as above) with solar winds