Hi All
Have a problem with a few of our Netonix switches not populating the MAC tables, all switches run on 1.5.0 firmware. Tested on a 1.5.1rc7 and same probelm still occuring. Is this a firmware issue? how can you get the mac tables to populate correctly?
Regards
Jock
MAC Address table not populating
- JockGraham
- Member
- Posts: 11
- Joined: Fri Apr 22, 2016 5:44 pm
- Has thanked: 1 time
- Been thanked: 0 time
-
Stephen - Employee
- Posts: 1034
- Joined: Sun Dec 24, 2017 8:56 pm
- Has thanked: 85 times
- Been thanked: 182 times
Re: MAC Address table not populating
The latest firmware is v1.5.2 try that out first and report back here if it doesn't work.
- JockGraham
- Member
- Posts: 11
- Joined: Fri Apr 22, 2016 5:44 pm
- Has thanked: 1 time
- Been thanked: 0 time
Re: MAC Address table not populating
Yes, tried it with the new firmware and still not populating with data. Anything else that I can try?
Regards Jock
Regards Jock
-
Stephen - Employee
- Posts: 1034
- Joined: Sun Dec 24, 2017 8:56 pm
- Has thanked: 85 times
- Been thanked: 182 times
Re: MAC Address table not populating
Try flushing the mac table. Also could you provide a screenshot of the Mac Table page and the config?
- hoppie
- Member
- Posts: 1
- Joined: Thu May 10, 2018 7:40 am
- Has thanked: 0 time
- Been thanked: 0 time
Re: MAC Address table not populating
We have the same problem after uploading latest firmware 1.5.14 Is there a fix for this, please?
Please see screenshot below:
Moderator note: Please attach image.
Please see screenshot below:
Moderator note: Please attach image.
5 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 63 guests