v1.4.0rc1-16 Bug reports and comments

[sirhc]

YES..you are right! LLDP changed to Enable and the graph became from mess to normal imediatelly and still hold.... watching

You have the same old saying over there about "a watched pot never boils"? - LOL

I think it may take several hours to happen but lets see.

I will work with Eric on this later today and see what we can determine is causing it, nice catch Daniel.

My guess is 1 of 2 things:
1) Added code we out in for the Manager to monitor the switches
or
2) The new graphs we put in for the DC model switches to graph power on the Device/Status Tab.

[IntL-Daniel]

As I reported in previous post... it appears it was able to change from mess status to normal "without any touch" and vice versa.

[IntL-Daniel]

It looks like the graph is slowly becoming mess up again. Already several short traffic drops again...so 20min with trafic about 100 Mbit/s is enough.

Edit: LLDP back to disabled and graph is fresh again...
Edit2: ..and again mess ..so even not 10mins is enough

[sirhc]

We will release v1.4.0rc11 tonight with a fix for the graphs Daniel.

Thanks again for catching it and working with us.

[IntL-Daniel]

I thank you for your quick response and the respect to your custommers.
BTW: About the Czech translation it will take me some time... I have to find some words in real Engish web UI first to understand the right meaning (and not to be like a automated translator :-) )

[sirhc]

I thank you for your quick response and the respect to your custommers.
BTW: About the Czech translation it will take me some time... I have to find some words in real Engish web UI first to understand the right meaning (and not to be like a automated translator :-) )

avatar.jpg (14.83 KiB) Viewed 8137 times

[sirhc]

v1.4.0rc11 released

As always read release notes and test on a switch easy to access.

[IntL-Daniel]

Thank you, finaly I will give a try.

[IntL-Daniel]

So it is nice to see the traffic graph real and correct again! Also I hope that I will never found these (false?) warnings in the log as never seen before RC10:

Code: Select all

Apr 11 19:35:03 switch[1632]: Detected warm boot
Apr 11 19:46:27 switch[1629]: 24V is out of range (22.2V)
Apr 11 19:46:39 switch[1629]: 48V is out of range (33.1V)
Apr 11 19:46:49 switch[1629]: 48V is out of range (44.8V)

Current status looks really good.

[IntL-Daniel]

One more TOPIC. I am not sure where is the root of this problem:

Each REBOOT, firmware update or power cycle of our Netonix means that connected AirFiber(s) 24 are unable to measure cable length and shows always <20m and all pairs SNR at 29dB. The 100% solution is to disable/enable LAN ports where AF24s are connected to and measurement on AF24s is back again in real numbers (35m) until another reboot or upgrade of Netonix.