LIST OF POEDEVICES THAT DO AN DO NOT WORK WITH WISP SWITCHES

[Dawizman]

Ubiquiti Powerbridge M10 ??

Yep. 24V just like all the other airmax M products.

[colinhowlin]

SIAE AlfoPlus 17GHz works at 48VH.
Pulls around 35W at load.

We were powering these with an AirFiber power supply.

[brent.s]

Has anyone tried to power a Cambium PtP820S radio off the Netonix yet?

I know it is a 48V unit, but not sure if there is any need for Pin swaps on one end for it to power correctly.

[cwachs]

What setting are people powering a Ignite MetroLinq with? Included power supply says 24v 1A. Does it use that full 1A? Are you using the 24VH on the Netonix?

[cwachs]

What setting are people powering a Ignite MetroLinq with? Included power supply says 24v 1A. Does it use that full 1A? Are you using the 24VH on the Netonix?

Finally found an answer:

MetroLinq
60 GHz - Port power should be set to 24VH (1.5A). Yup we tested it and confirmed no issue powering.

[sirhc]

You can power a Metrolink with 24V .75A but if you have a 24VH port available use it.

[givemesam]

i recommend making an edit to: viewtopic.php?f=6&t=1178

and say the metrolinq is supported fully on 24VH, and can also be powered on 24v. We have done both and it seems fine. (toughswitch did the 24v, and then got WISPsw and put it on the 24VH)

[gripper]

Has anybody tried:

Ceragon (IP-20c) ??

Radwin (5000 HPMP) ??

Wavion (2400Sect) ??

[gripper]

Oops...just discovered an earlier post that confirms Ceragon IP-20C "do in fact work with 48VH PoE and consume about 45 watts when fully online."
Thx to sswireless....

[George_EOL]

Has anybody tried:

Ceragon (IP-20c) ??

Radwin (5000 HPMP) ??

Wavion (2400Sect) ??

I have a Wavion/Alvarion N Sector running on the DC WISP Switch. 48VH but you need to run a crossover cable! 1+2>3+6 and vice versa. I haven't run up one of the b/g models yet but will have too soon!