Difinitive answer on powering Airfiber 5X

[rwrocket]

The bricks that come with AF5X are 24v, the toughswitch from UBNT seems to run them on 24v

My WISPSWITCH WS-12-250-AC seems to need the power set to 48v to power it on.

I am too scared to try 48VH in case it blows it up.

Are you able to confirm what power setting it should be working on?

*EDIT*

I think my switch might be faulty

It was complaining about a disconnected FAN and now for the second time it has gone into a kind of panic flash mode.
I just checked one of my other switches and I have a 24port wisp switch running AF5X on 24v no problem so I am guessing this is a fault.

[Julian]

That switch may need a repair - it sounds to me as though your 24v regulator is acting up, which is usually a pretty quick and painless fix.

Please RMA, instructions can be found here: http://forum.netonix.com/viewtopic.php?f=6&t=1259

We'll get you up and running in short order.

[sirhc]

There is a search feature to find these answers.

But there are ANNOUCEMENT and STICKY posts at the top of each forum which all users should read.

Read this post: viewtopic.php?f=6&t=1215#p9040

And this post: viewtopic.php?f=6&t=1178

[rwrocket]

I did actually see the other thread about AF5X power however the cable length and 24/24VH thing was confusing me greatly as I now know I had a faulty switch and plugging the radio in a 1M patch lead at 24v still did not power up.

Also the FAN issue.

thanks for the replies