Protection diode fried
- Asuinetwork
- Member
- Posts: 5
- Joined: Wed Sep 13, 2017 12:23 am
- Has thanked: 0 time
- Been thanked: 0 time
-
sirhc - Employee
- Posts: 7416
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: Protection diode fried
Asuinetwork wrote:I would just replace the board can i order the board and how can i obtain it ?
We are talking about the WS-8-150-DC unit.
There is but a single board in that unit as the DC power supply is on the same board as the switch.
So basically the board is 85% to 90% of the cost of that unit
Parts in a WS-8-150-DC
White Retail Box
Metal Chassis and screws
Fan and screws
DC Terminals
Red and Black Terminal Wires
Decals and Rubber Feet
Board <- MOST OF THE EXPENSE OF THIS UNIT
Chances are we can fix the board if you RMA it but I understand you're in another country.
If the DC controller chip is fried chances are you will see not damage to the outside of the chip as you only went over the allowed voltage by less than 10 volts at 84V DC in. You would not see a smoking gun crater in the board just a dead chip.
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Who is online
Users browsing this forum: No registered users and 31 guests