Most of our units are DC and we rely on the netonix to report to us when the power is low. But the problem we are experiencing is that when the power hits the set point, the power fluctuated and will send us 100 alerts, and if power is restored we have no way of knowing until we log in.
Would it be possible to have a set "recovery" voltage which would create a window for the low point to fluctuate without sending tons of alerts, and also have the ability to alert us when power is restored or goes past the upper voltage set point?
Also we had mentioned in the forum about the possibility of controlling power to a poe port so we can intelligently power a cabinet fan.
sirhc wrote:We can do a firmware feature where we turn POE ON and OFF for a port that you use to control a fan then use this to power the fan:
https://www.streakwave.com/Itemdesc.asp ... erTap&o1=0We may put this in v1.4.8 once we start with that thread.
This would be huge for us as with the fans staying on, we have found the netonix to get too cold and start to condensate in cold damp weather, where if we could power down the fan the cabinet would remain warm and keep this from happening.
Thank you in advance! Charles...
