v1.5.1rcX Bug Reports and Comments

[sirhc]

Well first try telling the Manager NOT to monitor it and see what happens. If there is a BAD connection/path from the Manager to the switch "maybe"????

Next I would try factory default and set back up.

[wirelessblue]

In looking at top output in the console, I see seven "switch" processes and one "dropbear" that are all basically taking 10% CPU. Is that what should normally be happening?

[wirelessblue]

Well first try telling the Manager NOT to monitor it and see what happens. If there is a BAD connection/path from the Manager to the switch "maybe"????

Next I would try factory default and set back up.

I removed it from Manager. No change on the switch itself. I also shutdown Manager completely and that made no difference.

[sirhc]

Well your down to trying a factory default and manually set back up I guess?

If that does not fix it then it has to be something with your network as I am not seeing this on any of my WISP deployed switches and I even just played with one here?

I know this is ok little help but I can not create this or see this?

[wirelessblue]

Well your down to trying a factory default and manually set back up I guess?

If that does not fix it then it has to be something with your network as I am not seeing this on any of my WISP deployed switches and I even just played with one here?

I know this is ok little help but I can not create this or see this?

Understood. Thank you. I'll see what I can figure out.

[wirelessblue]

It turns out I was still on 1.5.0 where I thought I had already upgraded that switch. I upgraded it to 1.5.1rc1 at 2:30am and am monitoring now. So far so good. I am also monitoring with Manager again with no issues so far. Thanks for your help.

[sirhc]

FIXED/CHANGED
- Fixed voltage input calibration for the WS-8-150-DC - RC1
- Fixed services running on IPv6 - RC2
- Fixed being able to bypass console login by hitting CTRL-C - RC2
- Fixed MSTP setting instance forwarding state - RC2

ENHANCEMENTS

KNOWN ISSUES
- WEB UI issues when not at 100% Zoom on browser especially on VLAN TAB
- Some language templates need help - please private message Eric Stern to help
- IGMP snooping over VLANS, MSTP, and ERPS are still being developed

RC1 Released 6/20/2018
RC2 Released 7/10/2018

[sakita]

v1.5.1rc1 - Tested hibernation with the WS-8-250-DC ... goes in and out of hibernation correctly and as expected... except that upon resume from hibernation the board temperature reading is always unknown so the fan spins up to maximum speed and stays there. A warm restart (reboot from the UI) will bring back the board temperature and the fan will resume normal operation. Have tested this multiple times. Also noted power supply firmware is version 70.

Also tested the WS-12-250-DC the same way. On this model the board temperature reading is working after resuming from hibernation so no problem.

...and then v1.5.1rc2 is released

[slowe]

On the VLAN tab if the 'Trunk Port' has a vlan listed that is also below in the table, that vlan can't be excluded by setting the 'E'. We use to be able to, is that expected or a bug?

[mike99]

Don't know if that expected but trunk should be configure as an allow list like and not via the "U, T, Q, D" Tab. When you check the "trunk" option, you can change the default list
0-4095
for something like this
0-15,18-22,39-4095
None include VID number will be exclude juste like with the E option.