WS-12-250 on 1.5.0 Board Rev F
Port 4 is supplying 48v power even though the interface says it is off. We can plug in a polycom phone/wifi ap and it will be powered even though the port poe is off. The PoE light on the port is not lit. If we select 24v, it does change the output to 24v, but when Off or 48v is selected it outputs 48v. We used an ethernet PoE tester to double check. Not sure what triggered it, a ruckus r510 was powered on the port for a few weeks before we noticed, but it could have been a problem before that. Also even though the device is getting powered, it shows as 0 watts in the UI.
Tried soft reboot and unplug/replug power from the ups.
Port always powered no matter what UI says
Port always powered no matter what UI says
Last edited by aspen on Fri Sep 07, 2018 4:57 pm, edited 1 time in total.
-
sirhc - Employee
- Posts: 7416
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: Port always powered no matter what UI says
You have a failed or damaged MOSFET, you need to RMA it to get fixed
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
2 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 59 guests