I am getting this error on all ports on a WS-12-250-DC "Error loading cable diagnostics". I have a Ubiquiti PBE-M2-400 and it's pulling 25-30 watts rather than the normal 3-5 watts and I don't know if it's the radio or the cable. The radio is passing traffic normally. I've re-booted the radio several times and re-booted the switch. The other radios all seem to be drawing the 3-5 watts.
Has anyone seen this before or have any ideas of what could be the cause?
Thanks
John
cable diagnostics
- JohnWall
- Member
- Posts: 10
- Joined: Fri Feb 23, 2018 12:24 pm
- Has thanked: 0 time
- Been thanked: 0 time
-
sirhc - Employee
- Posts: 7416
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: cable diagnostics
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
- JohnWall
- Member
- Posts: 10
- Joined: Fri Feb 23, 2018 12:24 pm
- Has thanked: 0 time
- Been thanked: 0 time
Re: cable diagnostics
Will do. It's also giving me the message 'Error saving configuration!'. Then it takes a long time to apply, but it does when I refresh the screen.
I'll let you know the results early next week.
John
I'll let you know the results early next week.
John
- JohnWall
- Member
- Posts: 10
- Joined: Fri Feb 23, 2018 12:24 pm
- Has thanked: 0 time
- Been thanked: 0 time
Re: cable diagnostics
Thanks sirhc
Finally got the switch on the bench and upgraded the firmware. It seems to be working just fine now.
Finally got the switch on the bench and upgraded the firmware. It seems to be working just fine now.
-
sirhc - Employee
- Posts: 7416
- Joined: Tue Apr 08, 2014 3:48 pm
- Location: Lancaster, PA
- Has thanked: 1608 times
- Been thanked: 1325 times
Re: cable diagnostics
JohnWall wrote:Thanks sirhc
Finally got the switch on the bench and upgraded the firmware. It seems to be working just fine now.
I would factory default it in case there is any corruption in the config file.
Support is handled on the Forums not in Emails and PMs.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
Before you ask a question use the Search function to see it has been answered before.
To do an Advanced Search click the magnifying glass in the Search Box.
To upload pictures click the Upload attachment link below the BLUE SUBMIT BUTTON.
5 posts
Page 1 of 1
Who is online
Users browsing this forum: No registered users and 71 guests