Voltage graph not autoscaling?

[kiwitinker]

I have just upgraded our oldest Netonix (12 port DC) to 1.5.5 - which was a mission on its own, because it did not survive the upgrade from 1.44, so I had to climb the tower and do a console based factory install from scratch in the lab....

But it is now up and running and showing:
Firmware Version1.5.5
Board Rev F
Power Supply Firmware Version 70
Power Supply Board Rev B

But the input voltage graph on the Status page is not autoscaling. This is a feature I would love to have. Anything I can do to make it happen - please don't say I have to take the network down and scale the tower again ...

[Stephen]

That shouldn't be necessary, Most likely you need to clear out the cache for the page in your browser and refresh the page.

[kiwitinker]

Thanks Stephen,
That did the trick - not terribly obvious to me though ...