WS-8-150-DC No Throughput

[ogryry]

Hi,

New install. Only used these a couple of times....

I made sure firmware was up to date then set static IPv4 info and enabled POE output voltage on appropriate ports. The switch does not appear to have any throughput; you can see it on the network but a device connected to any port will not get an IP address from the Antennae's DHCP server. If you bypass the switch it will.

I factory restored with no change. Any ideas?

Thanks,

Ryan

[JustJoe]

What version did yours ship with ?

If v1.5.5 then you need to read this thread:

viewtopic.php?f=17&t=6243

For most people with this problem, they need to download from this website and re-install the firmware.

v1.5.5 worked for most people.

Now the new v1.5.6 should also work.

[ogryry]

Well that was it. Shipped with 1.5.5. Reflashed 1.5.5 and all is good. How dumb. Thanks!

[JustJoe]

Glad that did it for you. :)

A little never hurts.