Firmware v1.2.0rc8 bug reports and comments

[sirhc]

WOW, nice work mike!

[mike99]

Just saw on previous post that port 1 and 100 are both untagged on port 13 and 14. I created VLAN 100 and set every ports from 1 to 12, one by one, to T so seem like that every port not configured are automaticly set to untag.

The problem with port range could be related, only configuring the first port and leaving by default the other, default value beeing U.

[sirhc]

Eric says you are keeping him BUSY Mike!!

Keep them coming!

[Eric Stern]

Just saw on previous post that port 1 and 100 are both untagged on port 13 and 14. I created VLAN 100 and set every ports from 1 to 12, one by one, to T so seem like that every port not configured are automaticly set to untag.

The problem with port range could be related, only configuring the first port and leaving by default the other, default value beeing U.

We do not support port ranges for this, you have to configure each port one by one.

[mike99]

We do not support port ranges for this, you have to configure each port one by one.

Then why accept the syntax ? On 1.2.0rc9, the syntax is still accepted.

Code: Select all

Netonix Switch# configure
Netonix Switch(config)# vlan 100
Netonix Switch(vlan 100)# port 1,3,5-7 t
Netonix Switch(vlan 100)# exit
Netonix Switch(config)# exit
Netonix Switch# show vlans
ID Enable Description 1 2 3 4 5 6 7 8
---- ------ ----------- -- -- -- -- -- -- -- --
1 true Management U U U U U U U U
100 true VLAN 100 T E E E E E E E

It would be nice to add port range and multiple port, something like:

Code: Select all

Netonix Switch# configure
Netonix Switch(config)# vlan 100
Netonix Switch(vlan 100)# port 1,3,5-7 t
Netonix Switch(vlan 100)# exit
Netonix Switch(config)# exit
Netonix Switch# show vlans
ID Enable Description 1 2 3 4 5 6 7 8
---- ------ ----------- -- -- -- -- -- -- -- --
1 true Management U U U U U U U U
100 true VLAN 100 T E T E T T T E