v1.3.9rc2 through rc14 - BETA/Release Candidate

[sirhc]

This thread is for posts regarding v1.3.9rcX BETA / RC

Issues fixed since v1.3.8

v1.3.9rc14 - Release 1/15/2015
- Fixed SNMP using 100% CPU
- Fixed config revert not working
- Added enable/disable VLAN to CLI

v1.3.9rc13 - Released 1/7/2016
- fix for clearing log
- added "clear log" CLI command

v1.3.9rc12 - Released 1/4/2016
- Fixed per-port graphs that were broken if switch was up less than 1 hour
- Fixed condition where DC2DC power supply failed to wake up switch from hibernation mode
- Fixed where unresolvable hostname could hang syslog server
- Fixed DC power supply voltage range
- Added LLDP Discovery
- Now retains log if log daemon is restarted
- CLI no longer saves config unless something was changed

v1.3.9rc8 - Released 12/15/2015
- Fixed UBNT Discovery name
- Ping Watchdog now disabled if port is disabled
- Changing Safe Mode Timer and ability to disable Safe Mode
- Ability to reset counters per port instead of all
- Log file formatting
- UI Enhancement for MAC table
- Add clear stats command to CLI

v1.3.9rc7 - Released 12/10/2015
- Fixed UBNT Discovery - FINALLY
- Fixed Linux log

v1.3.9rc6 - Released 12/02/2015
- Fixed Loop protection log entry refers to wrong port number
- Fixed Broadcast storm when using LACP and RSTP [Discovered by Thomas]
- Fixed Unable to change RSTP path cost for LAGs

v1.3.9rc4 - Released 11/30/2015
- Changed from mini-snmpd to net-snmp, a more common and well tested snmp daemon.

v1.3.9rc2 - Released 11/24/2015
- Fixed MAC table eating up CPU time when you have hundreds and hundreds of MAC entries. [Discovered by Francisco]

[Dawizman]

Upgraded one WS-12-250-DC to 1.3.9rc4 to see if it would fix my SNMP issues. Upgrade went smoothly, now only time will tell. Usually takes about a week before issues pop up.

[sirhc]

Upgraded one WS-12-250-DC to 1.3.9rc4 to see if it would fix my SNMP issues. Upgrade went smoothly, now only time will tell. Usually takes about a week before issues pop up.

Thanks you for posting and testing!

[Travis_WVN]

RC2 has 90% smoothed out the CPU issues on our network! Thanks for getting this out so fast.

[quantumx]

Updated a WS-12-250A RevB switch from 1.3.6 ->1.3.9rc2, no drama, and voltages in Power section of status screen now report properly with generic Addon SX gbic installed.

[lligetfa]

Upgraded one WS-12-250-DC to 1.3.9rc4...

Where is this firmware available from? Is rc4 the latest and if so why are others more recently reporting on rc2?

[sirhc]

Hey Les,

It is right under the download of v1.3.8

[lligetfa]

Who'da thunk it would be under stable? Not me.

I upgraded a MINI to rc4. The linux log bug I reported earlier is still there.

[lligetfa]

Who'da thunk it would be under stable? Not me.

I upgraded a MINI to rc4. The linux log bug I reported earlier is still there.

Same thing with the WS-24

Selection_014.jpg (43.02 KiB) Viewed 9544 times

[sirhc]

v1.3.9rc6 released see release notes above