v1.3.9rc2 through rc14 - BETA/Release Candidate

[Mola9850]

Hi
Have upload firmware 1.3.9rc7 in my SW24-A400 , either there is a bug in the firmware or so I have not read well enough in the forum . Here are 2 photos
i have upload to 11 other switch without problems .

[sirhc]

I "think" your referring to missing meters?

I "think" that you installed on 11 other units with no issue would indicate not a bug plus i rolled out on all mine with no issue.

Try to refresh your browser or close and re-open.

If that fails try the upgrade again.

[Mola9850]

upgrade again fix it ty. and ty for a super switch and fast firmware upgrade.

[mcmsys]

UBNT discovery is working on the 3 switches that I have upgraded. However, Host Name in Air Control is 'WISPSwitch', not the name that I have assigned to the switch. Is this just a bug, or am I missing something?

[Mikea]

As in many changelogs defined, ubnt discovery fine tuning is on roadmap.
I can confirm btw that device name returns a generic value of "WISPswitch" instead of the user defined name of the device.
This is only on the device response on discovery ping.

Netonix Discovery.jpg (151.21 KiB) Viewed 6994 times

[lligetfa]

Yes, the Ubiquiti Device Discovery Tool confirms that NAME and DEVICE TYPE are reversed.

EDIT: Actually not reversed but not right either. The contents that in the Name field don't show at all.

Selection_001.jpg (64.46 KiB) Viewed 6991 times

[Eric Stern]

I'll fix that in the next release.

[Kevo]

Does the 1.3.9rc firmware address snmp monitoring issues. I am using LibreNMS and it seemed like it was reporting traffic properly right after install, but now the traffic graphs are a bit crazy with large spikes with little in between. Throughput numbers on the switch itself seem fine.

[sirhc]

Does the 1.3.9rc firmware address snmp monitoring issues. I am using LibreNMS and it seemed like it was reporting traffic properly right after install, but now the traffic graphs are a bit crazy with large spikes with little in between. Throughput numbers on the switch itself seem fine.

Please read release notes at the top of this thread (Post 1)

There you will see that as of v1.3.9rc4 we fixed SNMP.

If you read further up in this thread you will read that several people have reported SNMP as being fixed.

[Kevo]

Thanks. I wasn't sure that the symptoms I was seeing was the same thing since it was working for me earlier. Probably should have read more of the thread.